![]() upg file format, simply load it on the Speedway reader or Impinj gateway in the exact same way firmware is loaded. If you received Impinj Speedway Connect in a. Step 2) Load Impinj Speedway Connect on your Speedway reader or Impinj gateway Connect AC Adapter or PoE to the Impinj gateway and wait for it to boot.The “more square” USB device end will connect to the USB Device port on the Impinj gateway.The flat USB Host end will connect to the PC.(Optional) Connect USB host-to-device cable and/or RS-232 cable between the gateway and PC.Connect the Impinj xSpan or Impinj xArray to a PC either directly or via router or switch using a standard Ethernet cable (no crossover required).See the SpeedwayR Installation and Operations Guide for details on the GPIO port.Ĭonnect power to the Speedway reader and wait for the Speedway reader to boot. RS-232 pins are located on the Speedway reader’s 15 pin GPIO port. The “more square” USB device end will connect to the USB Device port on the Speedway reader. The flat USB Host end will connect to the PC. (Optional) Connect USB host-to-device cable and/or RS-232 cable between Speedway reader and PC Take care not to cross thread the antenna cable.Ĭonnect the Speedway reader to a PC either directly or via router or switch using a standard Ethernet cable (no crossover required). Step 1) Start by setting up your Speedway reader or Impinj gateway hardware Speedway (R120/22/420) and xPortalĪttach antennas to the Speedway reader as desired. ![]() Impinj Speedway Connect is compatible with Impinj Speedway RAIN RFID readers (R120, R220, R420) and also with the Impinj xArray RAIN RFID gateway, Impinj xSpan RAIN RFID gateway, and Impinj xPortal RAIN RFID gateway. This article describes what to do when configuring Impinj Speedway Connect on-reader software including hardware setup and software installation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |